This work intends to contribute to the validation of the Tamengo Formation δ¹³C curve and elevate it to an international standard level. In addition, the detailed stratigraphic sections should provide an enhanced characterization of the palaeodepositional environment and promote Tamengo’s correlation with other well-known late Ediacaran sections in South America and worldwide.

Results and discussionTOP

Several sites were observed in the vicinity of Corumbá, then fresh outcrops at Corcal and Laginha Mines were selected, sampled and described for three detailed stratigraphic sections (Fig. 1) paired stable isotope geochemistry, in a scale never published for this unit before, in order to better comprehend its palaeodepositional environment. The limestones are mostly dark gray, range from pure to dirty, are variably recrystallized and some levels are dolomitized. In terms of sedimentary structures, they exhibit massive bedding, various types of cross stratification, from tabular to swaley, as well as erosional surfaces.

The Corcal sections are homogeneous, made of fine grainstones, often containing shell fragments, alternating with siltstones. There are coarser grainstones and fossiliferous rudstones towards the top of the section, as well as possible volcanic ash levels.

The Laginha section, located nearly 12 km southeast of Corcal Mine, on the other hand, exhibits miscellaneous facies. The section starts with dolomitic grainstones from the underlying Bocaina Formation, passes into Tamengo’s basal polymictic breccia, and then dolomitic to calcitic mudstones, wackestones, grainstones, and intraclastic breccias interbedded with marls and siltstones. The carbonates often contain extraclasts of various composition, such as quartz and mica.

High-resolution carbon isotopic compositions are very diverse between Corcal and Laginha sections. The lower interval at Corcal starts with δ¹³C values between 4.05 and 2.94‰ with a gradual increase to 6.97‰ at 13 m, with a small peak at 5.33 at 10 m. A rapid decrease follows to 4.94‰ at 14 m, and then persists until the end of the section, except for a 5.75‰ peak at 16 m. There are five outliers. The upper section starts and persist with δ¹³C values between 3.74 to 5.24‰ throughout the first 10 m, with a negative peak of 4.16 at 3 m. Thenceforth values range from 4.75 to 5.67 until 22 m, where there is a decrease to 3.40‰ followed by an increase to 5.20‰ at 23m and a second and final decrease to 2.83‰ at 24, 6 m.

The Laginha section starts with δ¹³C values of 1.53‰ linearly increasing to 3.14‰ at the Bocaina-Tamengo contact. There is a large gap in the register corresponding to the massive polymictic breccia bed. The initial dolostones from Tamengo Formation decline from 0.79 to -0.13‰, followed by a 500 m set of dolostones and limestones with tangled δ¹³C signal, ranging from -3.03 to 0.17‰, perhaps on a rising curve. There a second gap due to a massive intraclastic breccia body and the signal comes back at 10.75 m with a value of 1.92‰ followed by -2.74‰ at 11.5 m and an increase to -0.72‰ at 12.5 m. Thenceforth there is a clear negative peak of -2.14‰ at 14.90 m followed by the curve stabilization at values ranging from -0.33 to -0.76‰. There are two outliers at 18.05 and 19.05 m.

Concluding remarksTOP

These initial results reveal a homogeneous section at Corcal, in both stratigraphic and isotopic aspects. Laginha section, however, presents a complex isotopic signal and facies heterogeneity, which are not clearly connected. Nonetheless, it is clear that Bocaina and Tamengo formations have distinct isotopic signatures. It is necessary to investigate the origin of the isotopic fluctuations, whether they are related to primary conditions, diagenesis, or a combination of factors.

The δ¹³C curves are valuable tools for Neoproterozoic stratigraphic studies, nonetheless should be used with caution. Corcal is suitable for a chemostratigraphic reference section, but Laginha may be better suited to study the effects of paleoenvironmental and diagenetic variations on the isotopic signal.

ReferencesTOP